Vehicle mileage with the battery (battery deterioration during operation).Age of the battery (loss of performance due to aging effects).In the case of a test result which does not definitely indicate “Battery OK”, other influencing factors must be taken into account for better interpretation of the result. However, it is often obvious that the battery is reaching the end of its useful life. The indication “Battery OK” then apparently shows that the battery is in a good state of health. This applies in particular to test devices with which conductivity measurement is not possible, or battery testers in which no suitable test algorithm is implemented for new battery technologies such as AGM or EFB. Interpretation of the test results for a start-stop battery is more difficult than with conventional starter batteries. To compensate for inadequate charging by the generator, or to maintain a stable voltage while driving.During all stop phases, either at traffic lights, in traffic jams or when parking.The residual capacity is the energy which is available to supply the electrical consumers during certain situations: The residual capacity must be sufficient to also supply the consumers during the standstill. During driving and braking (in the case of a start-stop system with recuperation, which feeds regenerative energy into the battery) the battery must therefore charge sufficiently in order to reliably handle the next stop. Why are the residual capacity and charge acceptance so important for a reliable test result?įor a start-stop battery, good charge acceptance is very important because it needs to supply sufficient current during a journey with a large number of stops and starts: Consumers remain in operation during the standstill and the large number of engine starts also have to be ensured. The residual capacity (Ah) and charge acceptance (CA) can only be determined indirectly and imprecisely with these battery testers. With most battery testers, these two questions cannot be answered precisely, because they only measure the cold start current (CCA). How quickly is the battery recharged after a partial discharge?.How much active material is still available for storage of energy by the battery?.In addition to the state of charge, also known as the “SOC” (“State of Charge”), it is therefore also important to know: This effect is increased by the electrical consumers which have to be supplied by the battery, even when the engine is stopped. These batteries are subject to frequent starting processes and continual partial discharges. The battery test for an AGM or EFB battery is more extensive, as the demands on these special battery technologies are more complex. Test and assessment of a start-stop battery If the open-circuit voltage drops below 12.4 Volt, the battery needs to be recharged. A fully charged starter battery has a voltage of 12.8 Volt. However, the charge can also be measured with a voltmeter or a Multimeter. With maintenance-free batteries, there are usually no filler plugs, so that there is no possibility of measurement with a hydrometer. Most starter batteries are now maintenance-free. With this common type of battery, simply the determination of the open-circuit voltage provides adequately reliable information about the state of the battery, as with conventional starter batteries, only a powerful cold start current is decisive for full functionality. Testing a starter battery only takes a short time. Test and assessment of conventional wet batteries We have summarized the meaning of the test results for conventional SLIs and start-stop batteries for you. However, in the case of batteries for start-stop systems, considerably more factors must be considered. Tests of conventional starter batteries (SLI) can be carried out quickly.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |